Analytica GmbH AnaGate CAN duo Manual de usuario descargar pdf (Pagina 15)

2.2 TCP/IP settings

Proceed as follows to configure the TCP/IP parameters:

1. Switching the dynamic/static IP address

Here you can switch between static IP and dynamic (via DHCP) addresses. If DHCP

is being used, the remaining fields cannot be edited as this information is retrieved

from the DHCP server. In this case, a DHCP server must be available and accessible

in the network.

2. IP address (not DHCP)

The IP address is entered in a.b.c.d format (e.g. 192.168.1.1) and is permanently

stored in the AnaGate CAN Gateway.

3. Subnet mask (not DHCP)

The subnet mask is entered in a.b.c.d format (e.g. 255.255.255.0) and is permanently

stored in the AnaGate CAN Gateway.

4. Default gateway (not DHCP)

The default gateway is entered in a.b.c.d format (e.g. 192.168.1.200) and is

permanently stored in the device. Enter “0.0.0.0” if a default gateway is not required.

The inputs are taken over immediately after clicking the button „save settings “and saved

permanently on the AnaGate CAN Gateway. A restart of the device is not necessary for

activation of the settings.

Note: Maybe the ARP cache of the PC has to be deleted to find the device with the changed

IP address.

Chart 2-2: Browser interface: tcp/ip settings (AnaGate CAN duo)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 26 27

Sin comentarios

Analytica GmbH AnaGate CAN duo Manual de usuario Pagina 15