Analytica GmbH AnaGate CAN duo Manual de usuario descargar pdf (Pagina 18)

NOTE:

The factory reset is not possible directly after power on until complete loading of operating

system and firmware of the AnaGate. This initialization period is signalled via the yellow

activity LED. On power on the LED is switched on and after initialization the LED is switched

off.

NOTE: After the change of the IP address, the ARP cache of the personal computer has to

be deleted eventually.

2.5.1 Examining the TCP/IP settings

It is possible to check the current TCP/IP settings directly on the device..

After pressing shortly the „Reset“ button the AnaGate starts to pulse out the current TCP/IP

settings via the yellow activity LED. Pressing again the buttons stops the pulsing

immediately.

The IP address and subnet mask are pulsed out, one after the other. Following pulse codes

are used:

 Digits 1, 2, 3, ...., 9: 1x, 2x, ...9x Flashing (200ms delay between each flash)

 Digit 0: 10x flashing (200ms delay between each flash)

 Dot: 1x very fast flash

Between two single digits a delay of 1 seconds is made, and between the IP address and

subnet mask two fast flashes are pulsed out.

Beispiel: 1 9 2 . 1 6 8 . 1 . 1

■ ■■■■■■■■■ ■■ □ ■ ■■■■■■ ■■■■■■■■ □ ■ □ ■ □□

2.6 The digital inputs and outputs

Over the 10-pole pin row on the back of the AnaGate CAN Gateway four digital inputs and

four digital outputs are led out, which can be used freely. Since the IO's are electrically

isolated from the AnaGate CAN Gateway, they must be separately supplied via the pins 1 us

2 with a voltage by 3,3V - 24V DC.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 26 27

Sin comentarios

Analytica GmbH AnaGate CAN duo Manual de usuario Pagina 18